Voltase hobby: use

Showing posts with label use. Show all posts

Sunday, November 2, 2014

Use FM Radio Receiver

The project is a user-friendly and cheap FM radio receiver which produces the desired audio signals using integrated circuit to achieve the pre-processing units. During operation, the user is allowed to change stations and interact with the receiver by integrating a keypad and an LCD for communication. There are several functions that this radio receiver can perform including adjusting the threshold when picking up stronger or weaker stations, setting up 3 favorite stations for quick tuning, scanning up/down for next strong signal station, and tuning up/down a frequency.

A keypad is designed for controlling the receiver and the buttons are mapped to their corresponding functionality while the other buttons are not connected. The 4 main sub-components of the receiver include the LCD, the keypad, the favorite station storage, and the communication with receiver. Each of them is being controlled by their software components. The antenna transfers the incoming radio signal to the AR1010 FM radio receiver. To communicate with the AR1010, the I2C protocol is used since the sample code is available online. Also, the AR1010 is powered by 3V. The button presses on the keypad are scanned by the program.

Monday, September 8, 2014

Power Supply with regulator output use IC uA723

This circuit operating with IC uA723 and add amplified with transistor TIP31 or similiar transistor with TIP31 . Input voltage for circuit about 10 - 40 volt DC , formerly of AC voltage 220 volts or 110 volts , then lowered by the transformer voltage to 30 volts. And the supply output voltage from 1 volt to 35 volt DC you can adjust it on potentiometer R2.
See this circuit power supply below :

Output voltage transformer used 10 to 40 Volts . On resistor Rsc is the current limit set resistor. Its value is calculated as :

Rsc = 0.65 Volt

For Example : If you need current output 2.0 A

Rsc = 0.65 / 2.0 = 0.32 Ohm

So , you must use 0.32 Ohm to current output 2.0 A

Tuesday, September 2, 2014

Variable Power Supply Wiring diagram Schematic Use LM317

This is a Variable Power Supply Circuit Diagram Use LM317. A truly timeless schema. LM317 is a versatile and highly efficient 1.2-37V voltage regulator that can provide up to 1.5A of current with a large heat sink. Its ideal for just about any application. This was my first workbench power supply and I still use it.

LM317 VARIABLE POWER SUPPLY Circuit Diagram

Since LM317 is protected against short-schema, no fuse is necessary. Thanks to automatic thermal shutdown, it will turn off if heating excessively. All in all, a very powerful (and affordable!) package, indeed.

Although LM317 is capable of delivering up to 37V, the schema pictured here is limited to 25V for the sake of safety and simplicity. Any higher output voltage would require additional components and a larger heat sink.
Make sure that the input voltage is at least a couple of Volts higher than the desired output. Its ok to use a trimmer if youre building a fixed-voltage supply.

Possible uses:
Variable workbench power supply, fixed-voltage supply... Just about any possible application when no more than 1.5A is necessary.